LYNX DRIVE ON TRIAC MILL

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
davemusicmann
Posts: 12
Joined: Thu 14 Jan , 2010 14:35 pm

LYNX DRIVE ON TRIAC MILL

Post by davemusicmann » Tue 26 Jan , 2010 17:38 pm

I have a Denford CNC Triac which I am coverting to run on mac3, with a SEM type 30X2-44L spindle motor
The driver is a LYNX 08 I am having trouble getting it to work
The manual for this drive found on the net is slightly different to mine
I have attached a photo of the driver
Can anyone identify it and offer any help on running it without the rest of the triac electronics.

Thanks
Dave Mann
Attachments
LYNX 08.jpg
LYNX 08.jpg (153.35 KiB) Viewed 3100 times
Top
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: LYNX DRIVE ON TRIAC MILL

Post by Martin » Tue 26 Jan , 2010 19:24 pm

Can you post a clearer picture of the terminals in the bottom left?
Top
davemusicmann
Posts: 12
Joined: Thu 14 Jan , 2010 14:35 pm

Re: LYNX DRIVE ON TRIAC MILL

Post by davemusicmann » Wed 27 Jan , 2010 16:42 pm

Bottom left hand corner

If this is not good enough I will re-take the photo

I am very grateful of your help

Dave Mann
Attachments
LYNX 08 Left CornerL.jpg
LYNX 08 Left CornerL.jpg (99.4 KiB) Viewed 3088 times
Top
Post Reply

Return to “Triac”