Flashing light on smcu board

All info relating to the Denford Starmill CNC milling machines

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 5
Joined: Tue 10 Jun , 2014 15:11 pm
Hardware/Software: Denford Starmill

Flashing light on smcu board

Post by stavros007 » Fri 13 Jun , 2014 22:21 pm

Hi, I have a red flashing light on my Starmill smcu controller board , is this normal?
I also have 2 green lights also - just wondered if the red light was indicating emg or error or similar.
Denford starmill 1989 ,any help appreciated.

Thanks in advance

Post Reply