Starmill/PC Communication Issue
Posted: Mon 14 Oct , 2013 21:54 pm
Hi,
Up until recently my PC connected to the Starmill most of the time.
I found that on occasion, it wouldn't be possible to establish a connection between the mill and the PC.
I'd have to restart the mill a few times and then it would be possible to make the connection.
I found that over time the frequency with which I would have to do this was increasing, and then I found that the mill seemed to lose communication with the PC.
I didn't have time to look at the problem at the time but have now come back to it.
I went to switch the mill on today and found that the 7 segment display wasn't lighting up properly.
At the moment, when I turn it on it just shows a red dash (the central segment).
I found and downloaded the Denstep 7 Segment LED status and fault display.pdf but it doesn't seem to list this "dash".
Does anyone have any idea what this indicates?
Thanks in advance.
Up until recently my PC connected to the Starmill most of the time.
I found that on occasion, it wouldn't be possible to establish a connection between the mill and the PC.
I'd have to restart the mill a few times and then it would be possible to make the connection.
I found that over time the frequency with which I would have to do this was increasing, and then I found that the mill seemed to lose communication with the PC.
I didn't have time to look at the problem at the time but have now come back to it.
I went to switch the mill on today and found that the 7 segment display wasn't lighting up properly.
At the moment, when I turn it on it just shows a red dash (the central segment).
I found and downloaded the Denstep 7 Segment LED status and fault display.pdf but it doesn't seem to list this "dash".
Does anyone have any idea what this indicates?
Thanks in advance.