Page 1 of 1

coolant options

Posted: Wed 11 May , 2011 10:57 am
by Andycnc
Has anyone fitted flood or mist coolant to a starmill?

If this was fitted as a factory option, was anything special done to the mill? eg, a drain hole cut in the base, some extra guards/seals to prevent moisture ingress anywhere?

Thanks
Andy

Re: coolant options

Posted: Sat 26 Jan , 2019 18:34 pm
by LozHarropLures
Long shot on a ten year unanswered post, but has anyone any tips/advice on fitting coolant on a Starmill?

Re: coolant options

Posted: Wed 16 Dec , 2020 11:57 am
by Manny
Hi I am looking at doing this also, I see by the drawings it has an option for a mist relay, I don't pick my starmill up until Friday so will have a look at the electronics then :) Im looking at adding the fogbuster

Re: coolant options

Posted: Wed 16 Dec , 2020 17:53 pm
by TDIPower
have a loom on the novamill threads as various people have done it

Re: coolant options

Posted: Wed 16 Dec , 2020 18:38 pm
by Steve
Airmist does not require any modification to the machine. If set correctly there is hardly any residue left and it will evaporate away.