Disassembling Orac spindle

All info relating to the Denford ORAC CNC lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
lsteele
CNC Apprentice
CNC Apprentice
Posts: 40
Joined: Fri 06 Jul , 2012 9:35 am
Hardware/Software: Denford Orac

Disassembling Orac spindle

Post by lsteele » Mon 19 Nov , 2018 20:13 pm

Hi,

Despite relubricating my Orac spindle bearings I've been getting poor running (squeaking, slow to start) recently and the bearings feel a little rough. I decided to disassemble the spindle to inspect the bearings and probably replace them. I've taken the pulleys, nuts etc off the rear of the spindle, but I'm not having a lot of luck pulling the spindle out. I've improvised a bearing puller using some M8 studding (largest I had to hand), but I'm not getting anywhere. Plan now is to use a bigger studding size and longer handled wrenches. If that's no good I'll rework my bearing puller so I have four screws bearing on the headstock (with some scrap for the screws to bear on so they don't mar the surface), and gradually tighten them. I'm just posting to ask if anyone has done this and can offer any pointers?

Here's a couple of pictures showing what I'm doing:

https://photos.app.goo.gl/TyZQDR6DQCyouVXd6
https://photos.app.goo.gl/sgbC3sXVZf8sHPSy5

Cheers!

Luke

Post Reply