Orac Leader Air chuck

All info relating to the Denford ORAC CNC lathes

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
blakey235
Posts: 16
Joined: Fri 08 Oct , 2010 10:01 am
Hardware/Software: I have Harrison M250 with Anilam control +Bridgeport interact 1 with Heidenhain 407
just bought Denford Quatro with North East Electronics Control, and I use Edgecam for Programming
Location: Treforest South Wales
Contact:

Orac Leader Air chuck

Post by blakey235 » Sun 30 Sep , 2018 16:31 pm

Hi everyone I am trying to get hard (reversible) and soft jaws for a Leader air chuck as fitted to Orac and Easyturn circa 1980's the jaw serrations are Imperial 1/16 of an inch pitch, leader only supply metric now, any guidance much appreciated.


PS has anyone out there made a bar feed for the Orac?

Post Reply