Orac spindle drive problem

All info relating to the Denford ORAC CNC lathes

Moderators: Martin, Steve, Mr Magoo

MAX THE MILLER
CNC Expert
CNC Expert
Posts: 144
Joined: Tue 23 Aug , 2011 18:25 pm
Hardware/Software: Denford Triac PC. VR Milling 5.51.0.616

Re: Orac spindle drive problem

Post by MAX THE MILLER » Fri 20 Nov , 2015 13:12 pm

Colin.

I've sent you a Private Message (PM).

Ridgeback
Posts: 33
Joined: Sat 31 Oct , 2015 21:33 pm
Hardware/Software: Denford Triac with original hardware/software
Denford Orac recently updated with Mac3
Location: Redhill, Surrey. U.K.

Re: Orac spindle drive problem - resolution?

Post by Ridgeback » Tue 15 Nov , 2016 20:42 pm

Hi All,

I must apologise for not coming back to this post and completing the task I began. I too find it quite frustrating when I read into a possible solution to a problem only to find that you get hung out to dry with no final solution to that problem. I hope to give a more in depth reply at a later date, but for those who are after an instant and concise reply, it all turned out to basically be a failure of the V.F.D. (variable frequency drive) along with a few other smaller issues. I hope this might help point you in a direction which might move your project on in a positive way.

Colin.

Post Reply