Entering G code program to Orac video

[triac]

Hi All

Just uploaded some videos to Youtube for the Orac when used in original form, G&M codes.
Shows Entering a program, dry run program and cutting sequence, 3 videos in all. May be helpful for anyone just buying an Orac who doesn't want to go on the refit route.
Link http://www.youtube.com/watch?v=H_lKQvYgV4A
Another video with facing, turning, inside and outside radius, taper, threading and boring, all on 1 video. Must fit a greater nose rad tool for the taper cuts !!!!!
http://youtu.be/aUbmiMLHLD0
Rgds, Emgee