Fitting a 3d touch probe to a novamill.

All info relating to the Denford Novamill CNC Milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
bpmsl
CNC Expert
CNC Expert
Posts: 145
Joined: Mon 16 Nov , 2009 10:00 am

Fitting a 3d touch probe to a novamill.

Post by bpmsl » Sat 23 Feb , 2019 1:22 am

Hi folks,
I'm looking at getting a 3d touch probe for my Novamill. It's the type that goes open circuit when the probe tip contacts the work piece in any of the 3 axes. Does the novamill support this? I assume i would connect it to an aux input? I have an original rs232 control box. If so what gcode do i need to use to do a probing routine?

Any help would be much appreciated.

Many thanks
Barry .

Post Reply