Fitting a 3d touch probe to a novamill.
Posted: Sat 23 Feb , 2019 1:22 am
Hi folks,
I'm looking at getting a 3d touch probe for my Novamill. It's the type that goes open circuit when the probe tip contacts the work piece in any of the 3 axes. Does the novamill support this? I assume i would connect it to an aux input? I have an original rs232 control box. If so what gcode do i need to use to do a probing routine?
Any help would be much appreciated.
Many thanks
Barry .
I'm looking at getting a 3d touch probe for my Novamill. It's the type that goes open circuit when the probe tip contacts the work piece in any of the 3 axes. Does the novamill support this? I assume i would connect it to an aux input? I have an original rs232 control box. If so what gcode do i need to use to do a probing routine?
Any help would be much appreciated.
Many thanks
Barry .