VR Milling DXF Importer query
Posted: Tue 21 Apr , 2015 14:48 pm
Hi - I am using the VR Milling (Ver 5.49.0.613) DXF Importer to cut a simple profile out of 3mm steel. However, the Novamill only cuts 1mm deep and finishes, despite my entering 3mm on the billet depth and also the Z Retract Height, on the last screen. I assumed that it was going to continue going down in 1mm increments, but it only did one then finished. How do I make it do the whole lot?
Thanks.
Thanks.