REQ: Mirac leadscrew details

All info relating to the Denford Mirac lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Mad Professor
Posts: 10
Joined: Fri 16 Aug , 2013 14:21 pm
Hardware/Software: ---------------------------------
Denford Mirac S/N: E03726A,
Despatch Date: July 1990,
Electrics S/N: 39969,
OS: MS Dos 6.22,
MIRAC Ver2.25,
---------------------------------
Location: Isle Of Wight, UK

REQ: Mirac leadscrew details

Post by Mad Professor » Fri 20 May , 2016 19:33 pm

Hi All.

I have been reading over the user manuals for the mirac lathes, but I can't seem to find any details regarding the leadscrews.

Does anyone happen to know what leadscrews are used in the 1990 model?

Thanks for your time.

Best Regards.

Mad Professor
Posts: 10
Joined: Fri 16 Aug , 2013 14:21 pm
Hardware/Software: ---------------------------------
Denford Mirac S/N: E03726A,
Despatch Date: July 1990,
Electrics S/N: 39969,
OS: MS Dos 6.22,
MIRAC Ver2.25,
---------------------------------
Location: Isle Of Wight, UK

Re: REQ: Mirac leadscrew details

Post by Mad Professor » Sat 07 Oct , 2017 9:27 am

It turns out my Mirac is using 5mm pitch ball-screws, with 12 tooth pulley on the stepper, and 30 tooth pulley on the ball-screw, (2.5:1 ratio).

Best Regards.

Post Reply