Hi All.
I have been reading over the user manuals for the mirac lathes, but I can't seem to find any details regarding the leadscrews.
Does anyone happen to know what leadscrews are used in the 1990 model?
Thanks for your time.
Best Regards.
REQ: Mirac leadscrew details
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 10
- Joined: Fri 16 Aug , 2013 14:21 pm
- Hardware/Software: ---------------------------------
Denford Mirac S/N: E03726A,
Despatch Date: July 1990,
Electrics S/N: 39969,
OS: MS Dos 6.22,
MIRAC Ver2.25,
--------------------------------- - Location: Isle Of Wight, UK
-
- Posts: 10
- Joined: Fri 16 Aug , 2013 14:21 pm
- Hardware/Software: ---------------------------------
Denford Mirac S/N: E03726A,
Despatch Date: July 1990,
Electrics S/N: 39969,
OS: MS Dos 6.22,
MIRAC Ver2.25,
--------------------------------- - Location: Isle Of Wight, UK
Re: REQ: Mirac leadscrew details
It turns out my Mirac is using 5mm pitch ball-screws, with 12 tooth pulley on the stepper, and 30 tooth pulley on the ball-screw, (2.5:1 ratio).
Best Regards.
Best Regards.