MRC40 and DP50 setup
Posted: Wed 09 Aug , 2017 13:08 pm
Hi all,
I have just received a MRC40 router and DP50 dust extractor, but am having some problems setting it up. The instructions are a bit unclear and I'm not sure if parts are supposed to fit quite as they do. This primarily concerns the connection of the DP50 to the MRC40.
Firstly, I'd like to check that I have connected the correct end of the hose to the DP50, as below:
(Image 1)
This leaves we with the following end:
(Image 2)
If I insert it through the back left hole, only the nozzle can pass, but doesn't extend far and seems _very_ loose, as below:
(Image 3)
However, if I stick it through the hole on the left side of the case, there is an even bigger gap. Is this gap okay? If so, how/where do I connect the end of the hose in the enclosure? With the metal clasp?
(Image 4)
Many thanks for your time, I have a few more questions regarding the contents of the MRC40, but will post those in other threads to keep this ot.
A
I have just received a MRC40 router and DP50 dust extractor, but am having some problems setting it up. The instructions are a bit unclear and I'm not sure if parts are supposed to fit quite as they do. This primarily concerns the connection of the DP50 to the MRC40.
Firstly, I'd like to check that I have connected the correct end of the hose to the DP50, as below:
(Image 1)
This leaves we with the following end:
(Image 2)
If I insert it through the back left hole, only the nozzle can pass, but doesn't extend far and seems _very_ loose, as below:
(Image 3)
However, if I stick it through the hole on the left side of the case, there is an even bigger gap. Is this gap okay? If so, how/where do I connect the end of the hose in the enclosure? With the metal clasp?
(Image 4)
Many thanks for your time, I have a few more questions regarding the contents of the MRC40, but will post those in other threads to keep this ot.
A