Turret Tools can not rotated

General support, help and advice for Denford CNC machines (old and new)

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
suryadiwansa.harun
Posts: 2
Joined: Fri 11 Dec , 2015 10:43 am
Hardware/Software: CNC Turning Cyclone P
CNC Milling Triac

Turret Tools can not rotated

Post by suryadiwansa.harun » Fri 11 Dec , 2015 10:54 am

Dear all.
I have a problem with the CNC Turning Cylone P.
The turret tools post of that machine can not rotated (moved).
Please help me for troubleshooting that problem.

regards
Harun

Martin
CNC Guru
CNC Guru
Posts: 1605
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Turret Tools can not rotated

Post by Martin » Fri 11 Dec , 2015 15:57 pm

What type of toolpost is it?
Does it try to rotate?
Has a circuit breaker tripped?

suryadiwansa.harun
Posts: 2
Joined: Fri 11 Dec , 2015 10:43 am
Hardware/Software: CNC Turning Cyclone P
CNC Milling Triac

Re: Turret Tools can not rotated

Post by suryadiwansa.harun » Fri 11 Dec , 2015 21:49 pm

Martin wrote:What type of toolpost is it?
Does it try to rotate?
Has a circuit breaker tripped?
Hello Martin.
Thank you for your attention.

The type of toolpost is Barrifaldi 8 station turret.
I have tried to rotate it through the change of tool (turret index) by pushing the button manually and also programming, but it still not rotate.
I don know whether a circuit breaker has tripped. But before the problem occurred, there was a slight collision between the turret (tool) and workpiece.

As additional information, the Led Lamp of tool post drive is not turn on.

Regards
Harun

Post Reply