Page 1 of 1
Is this a Denford
Posted: Sun 17 May , 2009 20:01 pm
by rasp
Posted: Mon 18 May , 2009 8:05 am
by bradders
This looks like its a CONECT Router. We did a VR Milling software version for this machine at one time, I think it needed an EPROM upgrade as well to get the VR Milling software to run.
Posted: Tue 19 May , 2009 8:40 am
by Denford Admin
It sounds like the guy already has the version of VRMilling v2 which will connect to the Conect machines, so the EPROM must be up to date.
I must say that these machines work ok, but there is no chance of it 3D contouring at any speed - its a simple RS232 command system that takes one move at a time...unless you upgrade it to a Mach 3 system and update the motors and drives