Another Communication problem
Posted: Sun 21 Jun , 2020 13:12 pm
Hi All
I have bought a microrouter year 2001
I am having serious problems with connecting it to VR5.69 milling latest software
I have now bought 2 leads from USB to RS232
I am running WIN 7 64 bit
I have installed the ABB 64 bit motion control drivers
I have set the machine up as router DENSTEP
And still no avail
The board in the cabinet is showing 8
Which reading up its ready to go
I have checked the baud rate etc on the the device panel on the laptop
The machine parameters are the same
So I am now at my wits end
I am a engineer so I am a bit basic on the required needs for pcb boards and wiring im more mechanical
Can anyone help
Thanks
I have bought a microrouter year 2001
I am having serious problems with connecting it to VR5.69 milling latest software
I have now bought 2 leads from USB to RS232
I am running WIN 7 64 bit
I have installed the ABB 64 bit motion control drivers
I have set the machine up as router DENSTEP
And still no avail
The board in the cabinet is showing 8
Which reading up its ready to go
I have checked the baud rate etc on the the device panel on the laptop
The machine parameters are the same
So I am now at my wits end
I am a engineer so I am a bit basic on the required needs for pcb boards and wiring im more mechanical
Can anyone help
Thanks