X Jamming

All info relating to the Denford MicroRouter and MicroRouter Pro CNC Routers

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
andy_con
CNC Expert
CNC Expert
Posts: 175
Joined: Fri 05 Oct , 2012 20:06 pm
Hardware/Software: Triac Vmc with 6 station ATC
Starmills with ATC

X Jamming

Post by andy_con » Tue 07 Jan , 2020 9:53 am

this week my X has started jamming when doing a rapid move from the home position to the other side of the table. almost half way. if a run the x slower it does not jam.

is this common? is there a common fix?

thanks

Martin
CNC Guru
CNC Guru
Posts: 1706
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: X Jamming

Post by Martin » Tue 07 Jan , 2020 16:55 pm

It may just need lubricating with Silicone spray.

Otherwise the X axis nuts may need to be removed & cleaned out.

viewtopic.php?f=37&t=5500

Post Reply