unknown error messages

All info relating to the Denford MicroRouter and MicroRouter Pro CNC Routers

Moderators: Martin, Steve, Mr Magoo

Post Reply
Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

unknown error messages

Post by Large519 » Fri 23 May , 2014 23:33 pm

Hi, I am having issues connecting pc to machine (microrouter pro), I get the following error messages.

Drive reports incorrect toggle bit.????
And
Must use a setxxxlink function.????

Can anyone help and advise what to do??

Thankyou

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: unknown error messages

Post by Martin » Sat 24 May , 2014 0:08 am

What is the colour of the 7 segment LED in the electrical panel?
If it is not red then try to connect using EasyUgrader.

Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

Re: unknown error messages

Post by Large519 » Sat 24 May , 2014 0:26 am

Hi it was green.

I have just tried the easy up grader, but still get error message

Drive reports incorrect toggle bit.....

Have I got baud rate, bit rate etc setup wrong,??

Do you know what these should be set at?

Large519
CNC Expert
CNC Expert
Posts: 101
Joined: Wed 20 Mar , 2013 22:34 pm
Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape

Re: unknown error messages

Post by Large519 » Sun 25 May , 2014 1:08 am

After much investigation it would appear to be an issue with the pc, I was originally running mach3 on the system with my other router, but now I was planning to run a pro router on the same system using vr milling, a windows optimization check list I had done recommended by mach clearly has issues with other programmes.

Post Reply