Denford Software & Machines

Hi all,

is there a chance you could post up some electrical drawings that cover my Microrouter Pro V5 NS, serial no H04706 April 04

Thanks
Graham

I Hope these are the correct drawings

Thanks for the drawings, unfortunately these are not the ones for my machine, here is a photo of the control, as you can see from the pictures my set up has an external Parker XLT50-S stepper driver and an additional PSU.

Is there a chance you still have the drawings for this version.

Regards
Graham

Have had a look and cannot find the drawing for your machine.

Do you have a problem with it? I can probably help with that.

The machine was redesigned in 2006 and i attach the schematic for that.

This drawing will show the stepper motor drives you have on the PRO but the relays are now on a PCB.

I attach the diagram for the Microrouter Compact This has the relay arrangement as you machine with the Delay timer and the spindle control relays.

Thanks Steve,

I don't have a problem, I was trying to work out if I could connect a 4th axis via another external drive.

Graham

Have a look here:
viewtopic.php?f=54&t=3576

Step3 and Dir3 are the 4th axes

Thanks for the tip.

Regards
Graham