I upgraded my micromill VR Milling software to version 2.3.
Since then it will not let me jog any two axis at the same time with the computer keyboard.
It used to jog x and y together if you pressed both buttons.
Anyone know how to fix this?
Micromill directional control.
Moderators: Martin, Steve, Mr Magoo
Re: Micromill directional control.
I don't think you have ever being able to jog more than 1 axis at a time in either VRMilling version 2 or 5.
Re: Micromill directional control.
Hmm, maybe I am loosing it. It was 2006 last time I run it and I was sure I could then.
Are you saying this is just not possible.
Are you saying this is just not possible.
Re: Micromill directional control.
I am sure Admin will confirm this in the morning.
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Micromill directional control.
I confirm none of the windows software has been able to manually jog two axes at once from the keyboard.
Maybe it was the DOS software that allowed you to ??
Maybe it was the DOS software that allowed you to ??
Re: Micromill directional control.
OK. I guess we will drop that and consider it a memory lapse on my part 