Microturn 2000 - Light does not work

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Microturn 2000 - Light does not work

Post by Benny » Fri 28 Mar , 2008 16:13 pm

Customer writes in ...
Microturn 2000 - light will not work with brand new bulb

Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Microturn 2000 - Light does not work - USA

Post by Benny » Fri 28 Mar , 2008 16:13 pm

The light unit is wired to the 24volt output of the transformer.
Check/Replace the 6.3amp fuse (F5) on the 24v output of the transformer.
Make sure the On/Off switch for the light unit is “On”. If the switch is bad, join the 2 blue wires going to the switch to bypass it.
Check voltage coming into the light unit.
Check the output voltage of the transformer in the light unit (small white wires).
Check the contacts to the bulb, clean and tight.
Some people have replaced the unit with an “Under the Cabinet” light fixture from the local home improvement store and wired it to the 110v side of the transformer.

Post Reply