Micromill 2000 year 2002

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
illmakemyown
Posts: 31
Joined: Tue 18 Mar , 2008 4:23 am
Location: Florida USA

Micromill 2000 year 2002

Post by illmakemyown » Tue 25 Mar , 2008 5:28 am

Does a Micromill 2000 need a certain cable to hook up to my computer, or can i go to any computer store and buy a cable? thanks

Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Post by Benny » Tue 25 Mar , 2008 14:55 pm

If you are using RS232 (for your Denstep control card) and not USB, Denford has found success with the Lindy PC/Fax/Modem RS 232 Cable. It is a 9 Female PIN/25 Male PIN serial cable.

Post Reply