Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
johnsonp3
Posts: 1
Joined: Tue 13 Nov , 2012 19:19 pm
Hardware/Software: Micromill 2000

Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5

Post by johnsonp3 » Tue 18 Dec , 2012 20:53 pm

Can you help me identify my machine, and tellme what drivers and software it came with?

Micromill 2000
Ser. # 57598
Denmint v2.0/S/B19-JD5


thanx
paul johnson

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5

Post by Denford Admin » Wed 19 Dec , 2012 14:37 pm

It will have run from VR Milling version 2.xx
This is the inspection document but doesn't tell you much more.
Attachments
57598.pdf
(42.88 KiB) Downloaded 677 times

Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5

Post by Martin » Wed 19 Dec , 2012 21:14 pm

It looks as if it will have been shipped with VRMilling Version 2 software.

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1449
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5

Post by Steve » Wed 19 Dec , 2012 21:35 pm

It should say on the serial number label on the side of the machine.

The EPROM will work with VR Milling 2 or 5

Post Reply