Easiturn 3 Inverter replacement

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
SigTech
Posts: 1
Joined: Fri 30 Mar , 2007 18:32 pm

Easiturn 3 Inverter replacement

Post by SigTech » Sat 31 Mar , 2007 11:55 am

The IMO Jaguar (Commander?) Inverter has given up the ghost. I tried replacing the internal mains fuse but it just blew again. The two Inverters that I have on other machines and all others that I have seen use seperate inputs for fwd and rev but the Jaguar only uses 1. Does anyone have a wiring diagram for the drive control circuit?
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 02 Apr , 2007 13:31 pm

Have just put this up:
viewtopic.php?p=2765

I think the drive will run FWD by default, unless you make the REVERSE input
Top
Post Reply

Return to “EasiMill / EasiTurn”