Easiturn control cabinet removal

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
EVguru
Posts: 14
Joined: Wed 11 Aug , 2010 14:04 pm

Easiturn control cabinet removal

Post by EVguru » Sun 31 May , 2020 18:08 pm

I'm trying to take the control cabinet off the top of my Easiturn. It uses the same kind of mounting collar as my Easimill, with the control cabinet sandwiched between the collar flange and the actual lathe cabinet. There aren't any set screws holding the collar into the lathe, at least none I can even get a finger to through the small wiring access hatch.

Has anyone taken one off?

Martin
CNC Guru
CNC Guru
Posts: 1719
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Easiturn control cabinet removal

Post by Martin » Mon 01 Jun , 2020 7:01 am

It`s a while since have taken one off.

From what I remember there is either one or two grub screws on the collar the control sits in underneath the control.

Post Reply