All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 1
Joined: Thu 08 Nov , 2018 12:49 pm
Hardware/Software: Easiturn 3 CNC Lathe


Post by Thermosense » Thu 08 Nov , 2018 13:02 pm

This is Eric Dixon from Thermosense Limited based in Radcliffe, Manchester. We have recently purchased an Easiturn 3 CNC Lathe Machine in an auction. The problem is, we have no experience in using CNC machines and was wondering if you know of anyone in the Manchester area that could offer any basic training and or setting up time on site. We know this is a shot in the dark but have been told by the manufacturer that because it is more than 25 years old that they cannot help us.

If you could response via email that would be ideal. Email address: eric.dixon@thermosense.co.uk or if you would rather call, please use 01628 531166.

Any help would be appreciated!

Best Regards,

Eric Dixon

Post Reply