Loading metric programs to a pnc2

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
jmini
Posts: 8
Joined: Fri 24 Mar , 2006 1:12 am
Location: West Midlands

Loading metric programs to a pnc2

Post by jmini » Wed 24 Apr , 2013 16:26 pm

Does anyone know how to load a metric program into an easyturn3 lathe with a pnc2 control via the serial port (rs232)

I have tried putting FC (Function metriC) at the start of the program but this generates the
same error message as the first XZ move (target position is outside table limit)

if I type a program directly into the machine setting metric units first then it will run as a
metric program so M/C will accept metric units

any help would be gratefully received

jmini

Post Reply