CNC Fanuc 6T system not boot

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
pisit
Posts: 11
Joined: Mon 05 Dec , 2011 13:02 pm
Hardware/Software: FANUC Controller

CNC Fanuc 6T system not boot

Post by pisit » Mon 09 Jan , 2012 6:42 am

Hi all, I have problem with machine.
CNC Lathe Fanuc control 6T I press the power on then monitor (display) not show anythings.
The system not start cann't do anythings. Help me please. :dumbfounded:
+ 5 VDC + 24 VDC are OK. 3 phase 200 VAC OK.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: CNC Fanuc 6T system not boot

Post by Denford Admin » Mon 09 Jan , 2012 11:20 am

I'm sorry but none of us here have any information or knowledge of the Fanuc 6-T control.
However, the 1st thing I'd do is check for a fuse behind the monitor

pisit
Posts: 11
Joined: Mon 05 Dec , 2011 13:02 pm
Hardware/Software: FANUC Controller

Re: CNC Fanuc 6T system not boot

Post by pisit » Tue 10 Jan , 2012 6:29 am

The monitor is worked. But it's not data for show. (I mean display have light but not have anythings show on it)
Now I try to check IC on CPU board. Buble board, CCR board and mem board.
I have not board for spare so I need to know and focus of problem.
If you have any comment please let me know and thanks for you service.

Post Reply