parting ali help
Posted: Wed 12 Jun , 2019 18:47 pm
i have a cyclone with a toe80 toolchanger .its all working mach 3.
i have a 3mm hss parting tool (ill buy different if advised)
i am struggling to part 25mm aluminium with it .
its snatching grabbing sounds terrible vibrates .
i can see the tool lifting a bit.
if something is loose or worn i will fix it,
But i need a base to start with
with this machine and tool what rpm and feed per rev do owners of this machine use for parting 25mm aluminium
cheers
i have a 3mm hss parting tool (ill buy different if advised)
i am struggling to part 25mm aluminium with it .
its snatching grabbing sounds terrible vibrates .
i can see the tool lifting a bit.
if something is loose or worn i will fix it,
But i need a base to start with
with this machine and tool what rpm and feed per rev do owners of this machine use for parting 25mm aluminium
cheers