Z Axis Backlash/play
Posted: Wed 09 Jan , 2019 13:32 pm
The Z axis of the cyclone has a couple of thou backlash until very recently. Not I can push and pull the tool turret 0.4-0.5mm, I am pulling from the base as close to the ballscrew as I can get so guessing that it is either worn ballscrew or the bearings. Seems to have coincided with me taking off the chuck and removing software limit and doing a job on a faceplate.
Does anyone have any idea on how to pinpoint where this play is and eliminating it?
Does anyone have any idea on how to pinpoint where this play is and eliminating it?