Tool holders
Posted: Wed 04 May , 2016 10:20 am
I am very new to Cnc lathes , and dont know to much about them.
I purchase a old Denford Cyclone Cnc lathe a cpl months ago.And managed to run a few basic parts of now , even if i do say so my self there not to bad.
Now i am looking for some of the block tool holders to fit drills , boring bar in. They have 4 bolt holes and a 25.4mm bore.
Sorry i dont know the correct part number/ name for them.
Denford do not sell them, anyone know where i can purchase a 2 of 3 of them
Ron
I purchase a old Denford Cyclone Cnc lathe a cpl months ago.And managed to run a few basic parts of now , even if i do say so my self there not to bad.
Now i am looking for some of the block tool holders to fit drills , boring bar in. They have 4 bolt holes and a 25.4mm bore.
Sorry i dont know the correct part number/ name for them.
Denford do not sell them, anyone know where i can purchase a 2 of 3 of them
Ron