I am very new to Cnc lathes , and dont know to much about them.
I purchase a old Denford Cyclone Cnc lathe a cpl months ago.And managed to run a few basic parts of now , even if i do say so my self there not to bad.
Now i am looking for some of the block tool holders to fit drills , boring bar in. They have 4 bolt holes and a 25.4mm bore.
Sorry i dont know the correct part number/ name for them.
Denford do not sell them, anyone know where i can purchase a 2 of 3 of them
Ron
Tool holders
Moderators: Martin, Steve, Mr Magoo
-
- CNC Apprentice
- Posts: 87
- Joined: Sat 01 Aug , 2015 9:23 am
- Hardware/Software: 2001 Cyclone with toolchanger and Fanuc 21i control
Serial number - H00913.
Voltage 415V F.L.C 20A 50Hz 3Ph
1997 Triac VMCwith toolchanger and Fanuc O-M control
Serial number - 70826B.
Voltage 415V F.L.C 30A 50Hz 3Ph
Re: Tool holders
Hi, I just made a load of these for my cyclone. They are rough bored to 22mm the idea being they get bored true in the turret. You can buy a couple of these off me if you like, or you can have the two I already had which are bored to 25mm. James