Cyclone spindle encoder

All info relating to the Denford Cyclone lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
mike2424
CNC Apprentice
CNC Apprentice
Posts: 39
Joined: Sun 25 Oct , 2015 18:30 pm
Hardware/Software: cyclone tu150e /fanuc

Cyclone spindle encoder

Post by mike2424 » Wed 25 Mar , 2020 13:48 pm

Hello all

Just looking for some info here on the spindle encoder. First off I had a guy repair the Mint 3.28 board which had corrosion due to the battery. Now I don't know if this has anything to with it but I have no RPM reading on the screen display. I believe its working as the spindle speeds up and slows down with different speeds imputed . The override is working, just plain old 0 RPM on the screen . Any ideas on what I need to check ? Thank you for any ideas here. Mike

Post Reply