Fanuc controller specification required

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
spannerman
Posts: 18
Joined: Fri 06 Jul , 2012 16:36 pm

Fanuc controller specification required

Post by spannerman » Wed 27 Apr , 2016 16:31 pm

Do you have any information or a copy of the manual for Cyclone no H01164/1 built 2001 with GE Fanuc 21i-T control. The manual supplied with my machine is not for this model. I have a servo error and need details of the Fanuc equipment installed on the machine.
Top
Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Fanuc controller specification required

Post by Martin » Thu 28 Apr , 2016 9:55 am

Cyclone 21i Manual
Attachments
Denford-Cyclone-P-Fanuc-21i-manual.pdf
(3.97 MiB) Downloaded 1154 times
Top
spannerman
Posts: 18
Joined: Fri 06 Jul , 2012 16:36 pm

Re: Fanuc controller specification required

Post by spannerman » Thu 28 Apr , 2016 16:52 pm

Many thanks for the info but what I need is information to my specific machine. There is a servo fault requiring a replacement board. The service manual I have lists all of the Fanuc equipment and part numbers but its for the incorrect controller. The only way I can get over the problem is for the service guy to visit and take the controller apart to identify the board part number. Do you have a Fanuc equipment list for my machine?
Top
Martin
CNC Guru
CNC Guru
Posts: 1906
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Fanuc controller specification required

Post by Martin » Fri 29 Apr , 2016 10:53 am

If you can supply the Fanuc 21i control serial number. I will have a look through what we have left.
Top
Post Reply

Return to “Cyclone”