Compact 1000 axes not moving but axis movement counters are

All info relating to the Denford Compact 1000 and Compact 1000 Pro small routing machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Compact 1000 axes not moving but axis movement counters are

Post by bradders » Thu 08 Feb , 2007 8:49 am

My Compact 1000 axes are not moving but axis movement counters are.
Last edited by bradders on Thu 08 Feb , 2007 8:55 am, edited 1 time in total.

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Post by bradders » Thu 08 Feb , 2007 8:55 am

Take the side panel off the compact, locate the printed circuit board with RED LED's, fuses and relays. Locate the relay with 3 contacts on it (Usually long and rectangular) Manufacturer SCHRACK. Press the Emergency Stop button and note whether a 3 contact change state, if they don't, check that the RED 1mm cables to the back of the Emergency Stop Button are connected correctly and that they are properly located into the bottom 2 terminals on the 6 pin socket on the bottom Right Hand side of the printed circuit board with RED LED's, fuses and relays.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Thu 08 Feb , 2007 11:30 am

This picture of the compact distribution / relay pcb board should help clarify what you are looking at:
Attachments
Compact-1000-relay-board.jpg
Compact distribution relay board 2004 to 2006
Compact-1000-relay-board.jpg (119.15 KiB) Viewed 5126 times

Post Reply