Denford Software & Machines

I was wondering if the PCB engraver nextmove card should be programmed with a machine type and the machine serial number?
EasyUpgrader2 states it's special and no serial number set.
Is a Denford expert able to confirm what if anything should be programmed into the card NVRAM?

Many thanks,
GIllian

The PCB Engraver was never added to EasyUgrader & the PCB software does not look for it so no it does not need to be programmed.

You can put the machine serial number in if you want but it`s not required to run.

Thank you for the confirmation.