Denford suite throwing errors
Posted: Mon 16 Jun , 2014 2:59 am
After setting up the PCB file and using the wizard I get an error
"The work area is out the machine range X=0.00 Y=0.00 Z = 3.00"
There is no help file or documentation to help, and the suite refuses to engrave the board.
Before I engraved a few boards without any problems, no settings were changed.
Thanks,
"The work area is out the machine range X=0.00 Y=0.00 Z = 3.00"
There is no help file or documentation to help, and the suite refuses to engrave the board.
Before I engraved a few boards without any problems, no settings were changed.
Thanks,