Version 2 behaving badly

A forum for issues relating to the use of TechSoft 2D design and Denford CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
clivedackus
Posts: 1
Joined: Sun 09 Dec , 2007 17:01 pm

Version 2 behaving badly

Post by clivedackus » Sun 09 Dec , 2007 17:19 pm

The toolboxes on version 2 keep disappearing but will reappear if I right click and also as I move the cursor around the screen images of the cursor get left behind on tne screen. This is all very wierd and has only started happening since we upgraded from 1.6 to ver 2. Anyone out there got any ideas please?

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Mon 10 Dec , 2007 10:05 am

Have nvere seen this before with Techsoft, but it sounds like a software problem between the application and the graphics card.
To determine the cause, try turning graphics hardware acceleration off and try again.
Also check your graphics driver software is fully up to date.

Post Reply