Techsoft 2D design on RM CC3 networks - WINEXEC FAILED

A forum for issues relating to the use of TechSoft 2D design and Denford CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
Guest

Techsoft 2D design on RM CC3 networks - WINEXEC FAILED

Post by Guest » Mon 13 Feb , 2006 15:13 pm

I get the message “WINEXEC FAILED” when running Techsoft on a RM CC3 network

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Mon 20 Feb , 2006 11:31 am

You Must tick legacy applications in the RM stuff - otherwise get winexec failed memory low error when trying to plot to Denford machines. This is because there are some 16-bit applications / DLLs

This error message may also appear when the InstallShield setup.exe program is executed over a network. Copy all the files on the distribution disk to a local folder and run setup.exe from this folder.

Post Reply