Quickturn Mach post options

A place to talk about QuickTURN 2D Design - our first Lathe CAD CAM software for a very long time.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Quickturn Mach post options

Post by Denford Admin » Mon 13 Aug , 2012 13:46 pm

from version 1.15 onward, options have been added to change to format of the cnc output file generated by QuickTurn 2D.
This is so the programs will load and work on other CNC machines (eg, Mach 3 controls)

For Mach output, make the changes shown below...
Turn off Denford directives and check the other options are as shown.
When you come to the postprocess wizard, click the browse button and make sure the Save As filetype is set to Post Output.
Attachments
quickturn-post-options.jpg
quickturn-post-options.jpg (145.79 KiB) Viewed 8160 times

Post Reply