VR Milling 2.31 Password recovery

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
milburn
Posts: 3
Joined: Wed 31 Jan , 2007 17:44 pm

VR Milling 2.31 Password recovery

Post by milburn » Wed 28 Mar , 2007 13:45 pm

How do I recover the necessary password to access 'Setup Machine Parameters'?
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Thu 29 Mar , 2007 7:31 am

If you have not changed it from the default then it is "denny" (without the quotes). If was changed then Admin will be able to to post some information
Last edited by bradders on Thu 29 Mar , 2007 9:16 am, edited 1 time in total.
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 29 Mar , 2007 9:02 am

If the password has been changed, then I can only advise on how to recover it by private message, or email (technical at(@) denford dot co. uk)

Otherwise, it defeats the whole point of having a password, if everyone knows how to reset it :idea:
Top
Post Reply

Return to “VR Milling - All Versions”