Page 1 of 1

VCutter angle?

Posted: Thu 24 Sep , 2020 17:11 pm
by markymac
I've recently acquired some new tools for my router and was hoping someone could clarify what angle I should be using when setting up a VCutter.
TOOL SETUP.png
TOOL SETUP.png (37.39 KiB) Viewed 5906 times
On the packaging they use either an angle measured off the vertical or an angle describing the point (hopefully the pic I've attached will clarify what I'm struggling to describe)

any help would be greatly appreciated

Re: VCutter angle?

Posted: Thu 24 Sep , 2020 21:30 pm
by TDIPower
As far as i know its your drawing B

Pete