"Device Driver Called Failed" Error
Moderators: Martin, Steve, Mr Magoo
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
"Device Driver Called Failed" Error
I get a "Device Driver Called Failed" error and sometimes a "Time out on ICM (TX)" error when trying to connect to a Router 2600 with VR Milling Ver 5 after about 30% of mint down loading using a Laptop with XP and service pack 2
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
I would suspect the USB hardware on the Laptop is either poor quality, or the laptop power saving features are interfering with the USB communications.
Or its a USB cabling problem - as long as our software / firmware and USB drivers are all up to date, then this problem will only be due to hardware or wiring faults.
Or its a USB cabling problem - as long as our software / firmware and USB drivers are all up to date, then this problem will only be due to hardware or wiring faults.