VR 5 vs spindle Probe
Moderators: Martin, Steve, Mr Magoo
VR 5 vs spindle Probe
Hello is it possible connection spindle probe on Denford Triac PC whit USB control card?.... if so, how to connect, and where insert the macro. Regards
-
- CNC Apprentice
- Posts: 91
- Joined: Mon 20 May , 2019 15:15 pm
- Hardware/Software: Micromill 2000:
Nextstep-4 axis
Novaturn ns:
denstep card (from swap)-atc
Re: VR 5 vs spindle Probe
Dug up an old post, but i'm interested. I would like to be able to automatically probe tool heights after a tool change. Has this been attempted by denford?