VR Milling 5 Program Information machine move error

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
SANJAY SURI
Posts: 3
Joined: Thu 08 May , 2014 15:13 pm
Hardware/Software: Novamil plus VR Milling 5
Novaturn VR Turning 5
Router 2600 Pro (4 axis)
QuickCAM2D Design
QuickTurn2D Design
QuickCam Pro
Quick Cam4D

VR Milling 5 Program Information machine move error

Post by SANJAY SURI » Thu 08 May , 2014 15:44 pm

Apoliogies if this has already been answered somewhere on the forum but I could not find it.

When running a simple program in VR Milling 5 the 2D/3D simulation works fine but when I press the 'Program Information' button it gives a machine move error and states that 'G0 Linear Move Exceeds Limits'.

I have checked the program and work offsets and they are all in the range of the billet and run both the VR Machine and real machine and this works fine; in fact this error occurs each time I use this button for any program I open even the example programs provided by Denford.

A colleague suggested that the billet in 'simulation mode' appears to be outside the working envelope of the machine; below is a copy of the program:

(Curve S AP Novamill 8/5/14)
(Created by S.Suri)
[BILLET X80 Y60 Z10
N10 M03 S1000
N15 G90
N20 G00 X60 Y40 Z10 F10
N30 G01 Z-1
N40 G03 X40 Y50 R20
N50 G03 X20 Y40 R20
N60 G01 X60 Y20
N70 G02 X40 Y10 R20
N80 G02 X20 Y20 R20
N85 Z10
N90 G01 X0 Y0 M05

Post Reply