Toolin library

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
philipb
Posts: 3
Joined: Thu 05 Jul , 2007 14:31 pm
Location: Bakewell

Toolin library

Post by philipb » Wed 22 Jan , 2014 15:41 pm

We have just re-installed VRMilling to a replacement computer and up-dated the software to V5.55. All appears to working ok but there is only one tool the tool library (6mm ball nose (default)). From memory I thought this was pre-populated with a large range of tools. Any help please.

jams138
Posts: 3
Joined: Wed 25 Sep , 2013 14:11 pm
Hardware/Software: Micromill, Micromill2000, Novamill, Microturn

Re: Toolin library

Post by jams138 » Wed 25 Jan , 2017 17:23 pm

I realize that the previous post is a few years old, but I now have the same situation. A customer of mine has recently upgraded to VR Milling V5.64, and now in his tooling library, the 8MM End Mill tool is not available for selection. Is there a way to add this tool to the library or a procedure that is needed to reveal it as available?

Thank you.

Post Reply