VR Milling v5.48 released 23rd Feb 2012

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

VR Milling v5.48 released 23rd Feb 2012

Post by Denford Admin » Thu 23 Feb , 2012 15:52 pm

VR Milling v5.48 released 23rd Feb 2012
Check here to download the latest version of all software:
http://www.website.denford.ltd.uk/suppo ... -downloads

v5.48 - cutter comp errors - changed GetConcaveToConcave and GetConvextToConvext in CutterComp to handle arcs with the same centre point and radius (ie when programming circle segments/quadrants)
v5.48 - changes to Gerberread to cope with apertures defined as 0.0 diameter and to read polygon apertures
v5.48 - delays added to bigmint before brake is released (VMC drives not always fully powered up before the brake released)
v5.48 - delay to enable homing buttons when control panel 1st appears
v5.48 - fix an issue of skipping 2nd or 3rd blocks where no feedrate was programmed.

Post Reply