Micro Mill - mill cutting deeper at the end of a job

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Micro Mill - mill cutting deeper at the end of a job

Post by Benny » Fri 15 May , 2009 14:15 pm

Customer writes in ....

school is have a problem with the mill cutting deeper at the end of a job.
Attached is a progam that they have created. It seems to run ok in simulation but he says when the mill finishes it cut of the boarder that it keeps cutting deeper as it goes along. And is much deeper at the end than at the beginning.

What could be causing this.
attached is fnc
Top
Benny
CNC Expert
CNC Expert
Posts: 201
Joined: Fri 20 Oct , 2006 15:27 pm
Location: USA

Micro Mill - mill cutting deeper at the end of a job

Post by Benny » Fri 15 May , 2009 14:17 pm

see attached
Attachments
Denford.zip
see attached
(581 Bytes) Downloaded 551 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 18 May , 2009 16:47 pm

What material are they cutting ?
After this has happened, will the tool touch back onto Z0 at the top of the billet, or does it go into the billet ?

It could be the tool being pulled out of the spindle, or the Z axis losing position for some reason.
Top
Post Reply

Return to “VR Milling - All Versions”