WHAT ARE THE SYSTEM / COMPUTER REQUIREMENTS FOR VR MILLING 5

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

WHAT ARE THE SYSTEM / COMPUTER REQUIREMENTS FOR VR MILLING 5

Post by Steve » Thu 25 May , 2006 13:13 pm

WHAT IS THE MINIMUM SPEC SOMPUTER REQUIRED TO RUN VR MILLING 5?

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Thu 25 May , 2006 13:14 pm

System Requirements

IBM or 100% Compatible PC

3 1/2 Inch Floppy Drive (for registration disk)

Pentium III 500Mhz

128Mb RAM

Microsoft Windows 98 and above

CD-ROM Drive

50Mb free Hard Disc space

Open GL 3D Accelerator Graphics Card with 32Mb VRAM supporting 1024x768 resolution

Single Users :
'Single User' version requires 1 x free parallel port (for security dongle)

For Machine Interface :
RS232 machine interface requires 1 x free serial port
USB (optional) machine interface requires 1 x free USB port plus Windows XP/NT/2000 operating system

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Thu 12 Feb , 2009 16:48 pm

NB - The USB machine control aspect of the software will NOT work on 64-bit operating systems like Vista 64bit
This is because 32 bit USB device drivers are not supported on Vista 64.
However, there is a possibility that RS232 machine communication would work but we have not tested this yet.

Post Reply